Hyperion Project
Replies: 4 comments 1 reply
-
|
Priority set to 150 in the Android Grabber? P.S.: Issue on GitHub |
Beta Was this translation helpful? Give feedback.
-
|
It was 100, changed to 150, but it didn't help. |
Beta Was this translation helpful? Give feedback.
-
|
My LED layout is:
In android app I tried
I've uploaded the picture |
Beta Was this translation helpful? Give feedback.
-
|
OMG, I found where the problem is. I use WS2811 and it uses 3 leds as 1 led. So, I've decreased number of leds by 3 and it works well now. Btw, what number of leds should I setup in android app? |
Beta Was this translation helpful? Give feedback.
-
I've installed Hyperion 2.0.16 on my mini PC (Intel N100). The ~5-meter WS2811 LED strip (267 LEDs) is connected to a Wemos D1 R32 (ESP32), with WLED v0.15 installed. A 12V 4A power adapter is currently being used. The power is connected to the strip from one side at the moment.
I've installed hyperion-android-grabber on my TV (TCL 65 C828), which has 3GB DDR4 and an MT9615 processor.
The LEDs start from the top-left corner and go clockwise. The same LED layout is selected in Hyperion.
However, the colors are not synced. I'm unsure how to properly investigate where the issue lies — whether the LED layout is incorrect, the Android TV's performance is insufficient, or there are power-related problems (though single colors work well). What steps should I take to verify everything?
Beta Was this translation helpful? Give feedback.
All reactions